Overview
Designed for pole-mounted chainsaws, this 10” replacement bar restores precise overhead cutting capability. Pole saw bars endure significant stress from extended-reach cuts, and worn rails can cause chain derailment at awkward angles. A fresh bar ensures the chain tracks reliably even in difficult overhead positions.
Key specifications
- 10” pole saw replacement bar
- Hardened steel construction for durability
- Integrated nose sprocket for smooth chain travel
Compatibility
This pole saw bar is compatible with Greenworks models as specified above. Double-check the bar mount pattern and chain specifications against your pole saw’s documentation before ordering.
Installation notes
Ensure the unit is powered off and the chain brake is engaged before bar replacement. Remove the cover plate, extract the old bar, and clean the oil channel on the saw head. Mount the new bar, install the chain with correct cutter direction, and adjust tension until there is minimal sag on the underside.
Common questions
Q: Will this 10 inch bar and chain combo fit my Greenworks PS80L210 pole saw, or is it only for the PS80L00?
Yes, this combo is compatible with the Greenworks PS80L210 as well as the PS80L00 and PS80L212. It’s also made to fit Kobalt models 100SDAA041, KPS 1081-06, and KPS 2081-06, as long as your saw uses a 10” chain in the 25AP058X size.
Q: I have a Kobalt KPS 2081-06 pole saw—do I need to reuse my old hardware when installing this bar and chain?
In most cases, you’ll reuse the side cover, bar nuts, and chain tensioning components from your existing saw. When installing, make sure the chain is routed in the correct cutting direction and then adjust the tension so the chain lifts slightly from the bar but still snaps back into place.
Q: How do I know when this 10” bar and chain combo needs maintenance or replacement on my PS80L212?
If the chain starts cutting crooked, producing fine sawdust instead of chips, or needs frequent tightening, it usually needs sharpening or inspection. Also check that the bar groove and oiling holes stay clean, because poor lubrication can cause premature wear on both the bar and the 25AP058X chain.
