Overview
Designed as a plug-and-trim aftermarket replacement, this pre-wound spool fits directly into the trimmer head without any custom winding. Factory spools eventually run out, and hand-winding bulk line can be time-consuming and prone to tangles. This replacement spool provides properly wound line that feeds smoothly from the first tap.
Key specifications
- Pre-wound replacement trimmer spool
- Direct-fit for listed trimmer models
- Bump-feed compatible winding pattern
Compatibility
This spool is designed for Portland string trimmers as listed above. Confirm the spool part number, line diameter, and trimmer model before ordering to ensure a proper fit.
Installation notes
Disconnect the battery or unplug the trimmer. Remove the bump knob or spool cover by pressing the release tabs. Lift out the used spool, insert the new one with the line routed through the exit holes, and replace the cover. Pull the line to confirm smooth feed before starting.
Common questions
Q: Will this 62567 spool replacement fit my Portland 62338 or 63387 13” string trimmer, or is it only for model 62567?
Yes, this spool is made to fit Portland 62567, 62338, and 63387 13-inch string trimmers. It’s also listed as compatible with Greenworks 21272 and 21212, along with spool/cap replacements for 29082 and 29242, so the key is matching your exact model number before installing.
Q: Can I use this spool replacement if I also need the cap for my Greenworks 21212 or 21272 trimmer?
This replacement is intended for the spool application and is compatible with setups that use the 29082 and 29242 trimmer replacement spool plus cap arrangement on Greenworks 21212 and 21272 models. If your original cap is damaged or missing, it’s a good idea to confirm that your trimmer uses that specific spool-and-cap style so the spool feeds and locks in correctly.
Q: What’s the correct way to install this replacement spool so it feeds line properly in my Portland 62567 trimmer?
First, unplug the trimmer, remove the spool cap, and clear out any grass or debris from the spool housing before dropping the new spool in place. Make sure the line ends are routed through the eyelets correctly and that the spool sits fully seated before reinstalling the cap, otherwise the line may bind or fail to advance smoothly.
