Overview
This aftermarket replacement spool comes pre-loaded with trimmer line at the correct diameter and winding pattern for your trimmer. When the original spool runs empty or the line becomes brittle from UV exposure, swapping in a fresh spool is faster than re-winding. The pre-wound design ensures consistent bump-feed performance from the start.
Key specifications
- Pre-wound replacement trimmer spool
- 6-pack quantity
- Direct-fit for listed trimmer models
- Bump-feed compatible winding pattern
Compatibility
This spool is designed for Husqvarna string trimmers as listed above. Confirm the spool part number, line diameter, and trimmer model before ordering to ensure a proper fit.
Installation notes
Turn off the trimmer and remove the spool cover by pressing in the retaining tabs. Remove the old spool and wipe out the housing. Insert the replacement spool, thread the line ends through the eyelets, and snap the cover into place. Test the bump-feed mechanism by tapping the head and pulling the line.
Common questions
Q: Will this 6PC T35 trimmer spool fit my Husqvarna 525LST and 535RX, or do I need to check the trimmer head first?
Yes—these replacement reels are intended for Husqvarna units that use the T35 head, including models like the 525LST and 535RX. Before installing, confirm your trimmer is using a T35 head and matches part numbers 537185701 or 596784001, since fitment depends on the head style, not just the engine model.
Q: I have a Husqvarna 130C and 323L. Are these complete heads or just the spooled replacement reels for the T35 head?
These are replacement spools/reels only, not complete trimmer heads. They are made to drop into an existing T35 head on compatible models like the 130C and 323L, so if your housing or cap is damaged, those parts would need to be replaced separately.
Q: What’s the correct way to install these T35 spooled reels and keep them feeding line properly?
Open the T35 head, remove the old reel, and seat the new spooled reel so the line ends feed cleanly through the eyelets before snapping the cap back on. To keep the line advancing smoothly, make sure the spool is seated evenly, keep debris cleaned out of the head, and avoid forcing oversized line if your T35 setup is rated for a smaller diameter.
