Overview
This aftermarket replacement spool comes pre-loaded with trimmer line at the correct diameter and winding pattern for your trimmer. When the original spool runs empty or the line becomes brittle from UV exposure, swapping in a fresh spool is faster than re-winding. The pre-wound design ensures consistent bump-feed performance from the start.
Key specifications
- Pre-wound replacement trimmer spool
- Direct-fit for listed trimmer models
- Bump-feed compatible winding pattern
Compatibility
This spool is designed for Troy-Bilt string trimmers as listed above. Confirm the spool part number, line diameter, and trimmer model before ordering to ensure a proper fit.
Installation notes
Turn off the trimmer and remove the spool cover by pressing in the retaining tabs. Remove the old spool and wipe out the housing. Insert the replacement spool, thread the line ends through the eyelets, and snap the cover into place. Test the bump-feed mechanism by tapping the head and pulling the line.
Common questions
Q: Will this replacement spool fit my Troy-Bilt TB25S and Craftsman WS2200, or are there different spool versions for those trimmers?
Yes, this spool is made to fit the Troy-Bilt TB25S and Craftsman WS2200 models listed, along with compatible units like the TB22, TB25CB, TB25SB, WC210, WC2200, and WS205. The most important thing is matching your exact trimmer model to the compatibility list, because similar-looking spool heads can use different spool sizes or locking designs.
Q: How do I install this spool on a Troy-Bilt TB252S EC gas string trimmer without tangling the line?
First, remove the spool cap and take out any old line or debris from the head before inserting the new spool. Make sure the line ends are routed through the eyelets correctly and that the spool sits fully in place before snapping the cap back on; if the line is crossed or pinched during installation, it can bind instead of feeding smoothly.
Q: Will this spool also work on a Hyper Tough h2510, and what should I check if the line is not feeding correctly after installation?
Yes, it is designed to be compatible with the Hyper Tough h2510 and h2520 models listed. If the line is not feeding properly, check for dirt packed inside the spool housing, inspect the cap for wear, and make sure the spool is seated in the correct direction, since a misaligned spool is a common cause of feed problems.
